Silverado & Sierra Leaf Spring Noise Fix

How to Fix Chevy Silverado and GMC Sierra Leaf Spring Squeak

If your Chevy Silverado or GMC Sierra makes an annoying squeak, chirp, creak, pop, or clunk from the rear suspension, you are not alone. The sound may be most noticeable at low speeds, while crossing bumps, pulling into a driveway, or as the suspension flexes over uneven pavement.

In many cases, the noise is caused by movement and contact between the individual leaves inside the rear spring pack. When that is the source, the problem may be addressed without replacing the springs or repeatedly coating them with grease.

Spring-Things® pads install between the spring leaves to help isolate the contact points responsible for many common Silverado and Sierra leaf spring noises.

⭐ Common Silverado and Sierra Leaf Spring Noise Symptoms

Owners commonly describe:

• Squeaking or chirping from the rear suspension
• Noise while turning into or backing out of a driveway
• Squeaks and creaks at low speeds
• A pop or clunk over small bumps and uneven pavement
• Noise that appears to come from beneath the truck bed
• A sound that becomes more noticeable as the spring pack loads and unloads

These symptoms may point to leaf spring movement, but they do not prove that the spring pack is the only possible cause. Bushings, shackles, shocks, U-bolts, axle movement, exhaust contact, and other components can create similar noises.

If the truck clunks mainly while being rocked side to side while parked, read:
Rear Truck Clunk: Leaf Spring Noise or Axle Play?

🔍 Why Silverado and Sierra Leaf Springs Squeak

Rear leaf springs are made from several steel leaves stacked together. As the suspension moves, those leaves slide and shift slightly against one another.

Noise may develop because of:

• Direct contact between the spring leaves
• Dirt, grit, and road debris entering the spring pack
• Dry or worn factory contact pads
• Surface corrosion at the contact points
• Changes in load, towing weight, temperature, and suspension movement
• Worn bushings or loose suspension hardware

Grease or spray lubricant may reduce the noise temporarily, but it does not stop the leaves from continuing to move against one another.

For a detailed comparison, read:
Leaf Spring Isolators vs. Grease

🛠️ A Clean DIY Fix for Leaf-to-Leaf Spring Noise

Spring-Things® pads are designed to sit between the spring leaves at the contact points. They create a durable barrier that can help reduce the friction and movement responsible for many common squeaks, chirps, creaks, pops, and clunks.

Spring-Things offers several advantages over repeated lubrication:

• No grease or spray coating on the spring pack
• No drilling or welding
• No removal of the leaf spring assembly
• No wheel removal in most installations
• No repeated lubricant application

Quiet Your Silverado or Sierra Leaf Springs

Spring-Things® pads install between the rear leaf springs to help reduce movement at the contact points. Most installations can be completed using basic hand tools, a floor jack, and properly rated jack stands.

Shop Spring-Things Kits View Installation Instructions

⏱️ How Long Does Installation Take?

Most installations take approximately 15–30 minutes, depending on the truck, working conditions, and the installer’s experience.

🔧 Silverado and Sierra Fitment

Spring-Things universal kits are designed for many Silverado and Sierra trucks equipped with approximately 2.5-inch-wide rear leaf springs.

🎥 Watch the Spring-Things Installation Video

This video shows the basic Spring-Things installation process and pad placement.

View the Photo Installation Guide

How to Confirm the Leaf Springs Are Causing the Noise

Before ordering, try to determine whether the sound actually originates within the spring pack.

• Listen while the truck slowly crosses an uneven driveway
• Watch for visible movement between the spring leaves
• Look for polished or rubbed areas at the leaf contact points
• Inspect factory pads for wear, damage, or missing pieces
• Check bushings, shackles, shocks, and hardware for looseness or damage
• Remove loose cargo, hitches, tools, and spare-tire movement as possible causes

Spring-Things is most likely to help when the noise is caused by contact between otherwise serviceable spring leaves.

📝 Frequently Asked Questions

Will Spring-Things fix a squeak while backing up or turning?
It may, provided the sound is caused by movement or contact between the rear spring leaves. Similar noises can also come from bushings, shackles, shocks, exhaust components, or the axle assembly.

Does Spring-Things replace any suspension parts?
No. The pads install between the existing spring leaves and do not replace the leaf springs, bushings, shocks, shackles, or hardware.

Will Spring-Things work on a lifted Silverado or Sierra?
It may fit if the truck still uses a compatible leaf spring pack with suitable contact points. Aftermarket lift springs and modified suspension systems should be measured and inspected before ordering.

Will installation change the ride height or spring rate?
Spring-Things is designed to isolate contact points without changing the suspension geometry, spring rate, or intended ride height.

Does weather affect the pads?
The pads are designed for automotive use, but service life can vary depending on climate, road conditions, spring condition, installation, and vehicle use.

Will Spring-Things fix every Silverado or Sierra rear suspension noise?
No. The kit is intended for noise caused by leaf-to-leaf contact. It will not repair worn bushings, loose hardware, damaged springs, axle endplay, drivetrain backlash, or other mechanical problems.